Change Language :
About 10 times longer service life with iglide® J3
To find the ideal iglide® material for a manufacturer of high-end mountain bike pedals, we received different shafts of titanium and chrome molybdenum steel, as well as bearings of a competitor. On this basis we tested our iglide® plain bearings in the iglide® laboratory.
The trials were executed under the following test parameters:
Shafts: Titanium, chromoloy steel
Load: 657 psi
Slide speed: 0.098 ft/s
Result:
The iglide® J3 bearings have the lowest wear rate on both shaft materials (36.6 μm/km to 73.3 μm/km). These were the best test scores in the test. In contrast, the plain bearings of the competitor material wear out on both shaft materials at rates of 329.7 μm/km to 776.2 μm/km.
More Information
Now you may order the winner of the test:
The new endurance runner: up to three times more wear resistant than iglide® J up to 1,450 psi
iglide® J3
iglide® J3 - material data
iglide® J3 - the fast- and slow-motion specialist
iglide® J3 - material dataApplication examples
Do you wish to test a custom application?
We will gladly test your specific application as well. Simply use the contact form!
