1 from 2
igus-icon-lupe
igus-three-dimensional-model
- Part number: P210FM-0405-06
- Material: iglide® P210
- Shape: Flange bearings
- Dimensions:
- d1 4 mm
- d2 5.5 mm
- d3 9.5 mm
- b1 6 mm
- b2 0.8 mm
- Customize dimensions
- Manufacturing method: Injection molding
- Service life:
PFAS-tested: All iglide materials labeled as "PFAS-tested" were tested for the 96 PFAS substances considered critical for the environment and health using the SQP M1227 test method (LC-MS/MS and GC-MS) and do not contain any substances >0.1% by mass. This category excludes substances from the group of fluoropolymers.
- Good coefficients of friction and wear on almost every shaft
- Very little humidity absorption
- Extremely wear resistant especially up to 2900 psi in pivoting applications
- Versatile: good performance with many different shafts
- Good with edge loads
- Self-lubricating and maintenance-free
- Standard range from stock
iglidur® P210 | Specialist for pivoting and roller applications and more - good friction and wear values on almost any shaft
With iglidur® P210, the user has a versatile all-rounder material at his disposal, which has an above-average service life, especially in pivoting applications with medium loads of up to 20MPa. The versatile material has already proven itself in numerous customised solutions and as a bar stock material. Clip-on or pre-loaded designs and use in vehicle interiors are possible.
Typical application areas
- Agricultural engineering
- Mechanical engineering
- Furniture / Industrial design
- Textile industry
When do I use it?
- When a universal material is sought for use in damp environments
- When a very wear-resistant material is sought for pivoting applications in the medium load range
- When edge loads and impacts occur
- When the surface pressure of iglidur® J is not sufficient
When do I not use it?
- When a universal material with the greatest possible dimensional diversity is sought
- When a material for very highly loaded swivel applications is required
- When temperatures greater than +100°C occur
Unsure if it fits?