drylin® R aluminium shaft, AWI, imperial

Material: 6061-T6
Straightness: 0.004”/ft
Hardness: 75 HB
Surface: hard-anodized
mil-A-8625 Type III Class II
Layer Thickness: > .0016”
Surface Hardness: 450-550 HV
approx. (60 RC)
Roughness: RMS = 4-20
Spec. Electr. Resistance: 4*1011 Ohm mm2/m
Chemical Resistance: 2< ph<9
Standard saw cuts are +/- 0.04" (1mm)

Part No.

AWI-04

Outer diameter d [mm]

6.4 (0.25 in)

Design

solid shaft

drylin® R aluminium shaft, imperial, AWI is made from EN AW 6061/6060. It is hard anodized with a hardness up to 550 HV. Due to the technical surface finish slight color variations may occur between shafts. This shaft is cut to a tolerance of +/- 1 mm unless otherwise specified. Custom tolerances are available on request. Our iglide J and J200 liners pair best with our anodized aluminum shafting. A160 and E7 can also be used on this shafting material while our X liners should be avoided.