drylin® E stepper motor with stranded wire, NEMA 17

MOT-AN-S-060-005-042-L-A-AAAA product image

MOT-AN-S-060-005-042-L-A-AAAA technical drawing

1 of 5

drylin® E stepper motor with stranded wire, NEMA 17

Installation size: NEMA17/flange installation size 42mm
Protection class motor housing: IP40 (shaft seal IP52), motor with stranded wires IP40
Holding torque: 0.5Nm
Nominal current: 1.80A
Motor connection: Metric connector

Item no.

MOT-AN-S-060-005-042-L-A-AAAA

NEMA17: Small, but lots of power

This little motor has impressive torque and high RPMs. Reliable operation with quick movements of low loads.

Stepper motors from igus® are a good supplement to drylin® linear axes. They are characterised by their cost-effectiveness, their precision and easy control. They work reliably under the most varied environmental conditions (depending on the selected class of protection IP). The igus® stepper motors can be connected to the most common motor controls using standardised electrical connection.

Motors with stranded wires are the least expensive and the most common stepper motors. The connecting wires for this type exit from the housing and will be connected with a JST connector. They are usually installed in machines and equipment that have an additional housing or are used in clean environments.