- Part number: QSI-0203-04
- Material: iglide® Q
- Shape: Sleeve bearings
- Dimensions:
- d1 0.125 inch
- d2 0.1875 inch
- b1 0.25 inch
- Customize dimensions
- Manufacturing method: Injection molding
- Service life:
PFAS-tested: All iglide materials labeled as "PFAS-tested" were tested for the 96 PFAS substances considered critical for the environment and health using the SQP M1227 test method (LC-MS/MS and GC-MS) and do not contain any substances >0.1% by mass. This category excludes substances from the group of fluoropolymers.
- For high loads - wear-resistant on many shafts
- Excellent wear resistance, especially for extreme loads
- Recommended for extreme pv values
- Good coefficients of friction
iglidur® Q | For high loads - wear-resistant on many shafts
iglidur® Q was specially developed for extreme loads. Under high loads, iglidur® Q is one of the iglidur® materials with by far the best wear resistance. From a radial load of 25MPa, even the highly wear-resistant iglidur® W300 is surpassed. Special, extremely finely distributed solid lubricants in the material ensure that maintenance-free dry operation is guaranteed under any load.
Typical application areas
- Agricultural engineering
- Construction machinery
- Traffic engineering
When do I use it?
- For pivoting applications
- For very good abrasion resistance, especially under extreme loads
- For extreme p x v values
- If the material needs to be insensitive to dirt
When should I not use it?
- For use under water
- If temperatures are continuously higher than +135°C
- If high edge loads or heavy impact loads occur