drylin® R aluminium shaft, supported, AWMU, EN AW 6061/6060

1 from 3

Lightweight
Ideal in combination with liners made from iglide® J/J200
Low wear
Corrosion resistant
Aluminium EN AW 6060/6061 (ALU)

Part No.

AWUM-40

Outer diameter d [mm]

Hole pattern

Standard

Pitch T [mm]

drylin® R aluminium shaft, solid/hollow shaft, AWMP is made from EN AW 6061/6060. It is hard anodized with a hardness up to 550 HV. Due to the technical surface finish slight color variations may occur between shafts. This shaft is cut to a tolerance of +/- 2 mm unless otherwise specified. Custom tolerances are available on request.